GPS SHIELD SKG13C EXTERNAL ATTENA

DESCRIPTION

PRODUCT NAME: GPS SHIELD

PRODUCT DESCRIPTION:

                  Adding GPS to your Arduino has never been easier. Multiple GPS receivers attach easily to the shield, and with the SparkFun GPS Shield and the example sketch (check below), you will be able to locate your exact  position within a few meters. Here’s where we are. GPS also gives you amazingly accurate time.A connector for the popular SKG13BL GPS receiver is populated on the board. The regular GPS pins (RX, TX) are also broken out to a 2.54mm pitch header. The DLINE/UART switch switches the GPS module’s input/output between Arduino’s standard TX/RX pins or any digital pins on the Arduino (default setting uses pins 8 and 9 connected to TX and RX, respectively). A reset switch is included which is connected to reset of arduino.

Features:

Ø  Separate connecter for vcc and ground to connect to other devices

Ø  Standard Arduino sized shield

Ø  GPS signals broken out to a 2.54mm header for additional device connections

Ø  Arduino reset button

Ø  UART switch controls serial communications

Ø  Switch between PC and Arduino out interface

Ø  Ultra high sensitivity: -165dBm

Ø  Extremely fast TTFF at low signal level

Ø  Built-in 12 multi-tone active interference canceller

Ø  Low power consumption: Typical 22mA@3.3V

Ø  ±10ns high accuracy time pulse (1PPS)

Ø  NMEA Output?GGA,GSA,GSV,RMC

Ø  Advanced Features: AlwaysLocate; AIC

Ø  QZSS,SBAS(WAAS,EGNOS,MSAS,GAGAN)

Ø  UART interface: 4800/9600/38400/115200 bps

Applications:

  • LBS (Location Based Service)
  • PND (Portable Navigation Device)
  • Vehicle navigation system

PIN DETAILS:

Pin

Name

Details

1

D1

Tx of arduino

2

Tx

Tx of GPS

3

D9

D9 of arduino

4

D8

D8 of arduino

5

Rx

Rx of GPS

6

D0

Rx of arduino


Documents

Documents


Coding