PICKIT3 PROGRAMMER

Qty Discounts Unavailable ...
Price Unavailable
DESCRIPTION

DESCRIPTION

PICkit3 In-Circuit Debugger/Programmer Clone uses in-circuit debugging logic incorporated into each chip with Flash memory to provide a low - cost hardware debugger and programmer.
          The MPLAB PICkit3 allows debugging and programming of PIC® and dsPIC® Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit3 is connected to the design engineer's PC using a full speed USB interface.

PICKIT 3 FEATURES

  • USB (Full speed 12 Mbits/s interface to host PC)
  • Real-time execution
  • MPLAB IDE compatible (free copy included)
  • Built-in over-voltage/short circuit monitor
  • Firmware upgradeable from PC/web download
  • Totally enclosed
  • Supports low voltage to 2.0 volts (2.0v to 6.0v range)
  • Diagnostic LEDs (power, busy, error)
  • Read/write program and data memory of microcontroller
  • Erase of program memory space with verification
  • Freeze-peripherals at breakpoint
  • Program up to 512K byte flash with the Programmer-to-Go

    The MPLAB PICkit 3 allows debugging and programming of PIC and dsPIC Flash microcontrollers at a most affordable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a full speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming.

When the microcontroller installed, 28 feet, 40 feet left of the aligned single chip 28/40P (A) this flag on the A line jumper position.
Align the left foot SCM 8,14,18,20 8P/14P/18P/20P (B) of this identification line, short cap on the B position.
ICD2, KIT2, KIT3 6Pin through the crystal head or block connection with the programming, operation.
The seat supports the following microcontrollers programming:
PIC16/18XX 40PIN devices (16F59 excluded)
PIC16/18XX 28PIN devices (16F57 excluded)
PIC16/18XX 18PIN devices
PIC 8PIN/14PIN/20PIN devices (10FXX excluded)