POWER LINE CARRIER MODULE KQ-430F

Qty Discounts Unavailable ...
Price Unavailable
DESCRIPTION

DESCRIPTION

Communication over Power Line. This module is design to communicate between two device through Power line (e.g 220V power line) without any extra components.

FEATURES

  • Working rate:120~135KHZ
  • Interface baud rate:9600bps, the true baud rate is 100bps,250-byte buffer
  • Temperature:-25 degree~+70 degree
  • Humidity: 90%
  • Power:DC +5V  
  • Receiver:11mA  Transmitter:300mA  

Pin configuration

1P-AC: 220V AC voltage of the line of fire (or zero line)
2P-AC: 220V AC voltage zero line (or FireWire)
3P-+5 V: +5 V to send power (210mA), single income data can be vacant reduce power consumption
The 4P-GND: Digital circuit ground
5P-+5 V: +5 V operating supply 11mA, the lowest operating voltage to 3.3V but not recommended
6P-RX: TTL level, carrier data into, then MCU TXD
7P-TX: TTL level, carrier data out, then the microcontroller RXD
8P-MODE: mode selection, vacant or connected to 5V high ground is low
9P-NC/RST: reset pin (active low) frequent switching mode. Do not need this feature, the pin should be left 


Customers who bought this product also purchased...